User's Guide

Table Of Contents

be at least one hop away, and all devices between the AP and the ExtremeXOS switch must allow

Jumbo-Frame of IP 1550 bytes.

The following ExtremeXOS switches and APs support a VxLAN topology:

• ExtremeXOS Switches:

◦ X465

◦ X590

◦ X690

◦ X695

◦ X870

◦ X670-G2

• ExtremeWireless access points: AP3xx, AP4xx, and AP5xx with ﬁrmware version WiNG 7.4.0 or later.

When conﬁguring a VxLAN topology, conﬁgure only one VNI and one VTEP (switch IP address). If you

have a VNI that associates with more than one VTEP (switch IP address), you must conﬁgure a separate

VxLAN topology. You can use the same VNI, but associate it to a dierent VTEP (switch IP address).

Due to a hardware limitation of 512 access points per switch, conﬁgure more than one VxLAN topology

in a deployment that manages more than 512 access points. Each topology conﬁguration can use the

same VNI with a dierent VTEP.

Note

The VLAN ID in the VxLAN topology is shared within the Bridge@AP VLAN ID pool. The

VLAN ID cannot be duplicated among the Bridge@AP, Fabric Attach, and VxLAN topologies

for the same AP. Extreme Campus Controller does not allow a duplicate VLAN ID per site.

To conﬁgure a VxLAN topology in Extreme Campus Controller:

• Go to Conﬁgure > Policy > VLANs.

• Select Add and conﬁgure the VLAN parameters.