User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Gateway IP address.
Address Range
IP address range. Value is prompted by the subnet IP address that you configured.
Exclusions
(Available from the VLAN configuration) A range or single IP address that is excluded from the
greater Address Range. Save your VLAN configuration before selecting Exclusions to configure IP
address exclusions.
Related Topics
Configure IP Address Exclusions on page 274
Add an Interface on page 352
Configuring VLANS on page 270
Configure IP Address Exclusions
Exclude specific IP addresses or a range of IP addresses when configuring the IP Address Range for the
Local DHCP server.
Note
Save your VLAN ID configuration before configuring IP Address Range Exclusions for a Local
DHCP.
1. From the Local DHCP Settings dialog, select Exclusions.
2. Configure an IP Address Range or a Single IP Address that will be excluded from the larger IP
Address Range configured under Local DHCP Settings.
3. Add an optional comment indicating why these addresses are excluded.
4. To add a new comment, select New.
5. To save the excluded IP addresses, select Save.
6. After you save, you can edit or delete the saved exclusions:
• To edit the saved exclusions, select .
• To delete the saved exclusions, select .
Related Topics
Local DHCP Management Settings on page 273
Fabric Attach Topology
The Fabric Attach topology type allows an AP to attach to a Shortest Path Bridging (Fabric Connect)
Network. The client component on the AP communicates directly with the server on an edge switch (or
it can communicate with the server through a proxy) to allow the AP to request VLAN to I-SID
(backbone Service Identifier [IEEE 802.1 ah] mappings). The Fabric Attach topology type is similar to
B@AP with the added I-SID parameter. Fabric Attach can be configured on the Extreme Campus
Controller anywhere a B@AP topology can be configured.
Note
When Fabric Attach is configured, LLDP (Link Layer Discovery Protocol) is automatically
enabled on all APs associated with the topology. The setting cannot be disabled by users.
VLANS Configure
274 Extreme Campus Controller User Guide for version 5.46.03