User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Table 70: VLAN Configuration Settings (continued)
Field Description
Enable Device
Registration
Indicates that the wireless AP or switch can use this port for discovery and
registration.
Mgmt Trac Indicates that this port will be used to manage trac. Enable Mgmt Trac
to access the Extreme Campus Controller user interface through this port.
Associated Profiles
Select to display a list of configured Profiles. You can associate a VLAN to
a specific set of devices through the assigned configuration Profile for the
device group.
4. To configure advanced parameters, select Advanced.
5. Select Save.
Related Topics
VLAN Advanced Setting on page 272
VLAN Profile Settings on page 146
Associated Profiles on page 124
VLANS on page 269
Fabric Attach Topology on page 274
VxLAN Topology on page 275
Configuring a VxLAN in Extreme Campus Controller on page 276
Generate Browser Certificates on page 303
Associated Profiles on page 124
VLAN Advanced Setting
Configure the following parameters to optimize your network connectivity. Modifying the following
settings is optional. Consider changes thoughtfully.
Multicast Bridging
Select this option to enable forwarding of multicast trac (point-to-multipoint) between the wired
and wireless sides of the AP. Because multicasts consume a lot of 802.11 air time, when you enable
this option you must also specifically identify the types of multicast trac that you want forwarded
by adding one or more rules.
Multicast Rules
Add one or more multicast rules if you enabled Multicast Bridging. Multicast rules (point-to-
multipoint) permit trac that matches the rule. A multicast rule is defined as the multicast IP
address of the trac destination and a mask that allows a range of addresses to be matched by a
single rule. Extreme Campus Controller oers a predefined set of multicast rules. Select a preset
multicast rule or define a new rule.
Related Topics
Pre-defined Multicast Rules on page 273
Configuring a Multicast Rule on page 273
Configuring VLANS on page 270
VLANS
Configure
272 Extreme Campus Controller User Guide for version 5.46.03