User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
• Single NAT
• Double NAT
• Port Restricted Single NAT
• Port Restricted Double NAT
• Unknown
IPV6 valid values are:
• Not Available
• Available
• Unknown
WLAN Metrics. Enter the values for maximum Uplink and Downlink speed and load parameters for
the WLAN service.
The mobile device uses information from the WAN Metrics configured here to make network
selection decisions. The mobile device can determine if necessary throughput is available from the
hotspot before connecting. If the mobile device receives indication that the basic service set (BSS) is
at capacity, the device will not associate with that AP.
Connection Capability. The mobile device uses connection capability information to make network
selection decisions by determining which services are blocked or supported at the hotspot.
Configure up to 16 ports.
• To add a protocol, select New. Select the protocol, the port number, and the status associated
with the protocol. Valid status values include: Closed, Open, or Unknown.
Note
Make an eort to configure all ports and do not rely on the Unknown value.
4. After you have finished configuring the Network Characteristics tab, select OK to save the
configuration.
Related Topics
Configure Hotspot on page 232
Hotspot Identification on page 233
SP Identification on page 234
Online Signup on page 239
Online Signup
The hotspot Online Signup tab displays hotspot properties for Online Signup (OSU) users. Online
Signup allows users who are not part of the provider network to manually connect to the hotspot. It
also allows for added security for users who want to connect anonymously. To configure Online Signup,
you must configure a separate WLAN for OSU with Open Authentication or WPA2-Enterprise (802.1x/
EAP). Encryption is specific to the service provider. Credentials in the mobile device SIM Card
authenticate the user.
To configure the OSU WLAN that you will specify on the Online Signup tab:
1. Go to Configure > Network > WLAN Settings.
Configure
Hotspot
Extreme Campus Controller User Guide for version 5.46.03 239