User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Network Characteristics
The hotspot Network Characteristics tab displays network parameters for the hotspot.
To configure Network Characteristics for the hotspot:
1. Configure a WLAN Services Hotspot. For more information, see Configure Hotspot on page 232.
2. Select the Network Characteristics tab.
Figure 64: Configuring Network Characteristics
3. Configure the following parameters:
IP Address Type Availability. The mobile device uses the IP Address Type Availability information to
make network selection decisions. Select the level of restriction for each network type.
IPV4 valid values are:
• Not Available
• Public
• Port Restricted
Hotspot
Configure
238 Extreme Campus Controller User Guide for version 5.46.03