User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
3. Configure the following parameters:
Realm. The NAI (Network Access Identification) Realms list is a FQDN (Fully-Qualified Domain
Name) of the service provider. This is a list of realms that can be successfully authenticated. Each
realm may have up to four supported EAP methods.
Note
Wildcards are supported. For example, for realm, you can enter
*.extreme.area120.com, instead of entering specific realms.
To add realms:
a. Select New.
b. Enter a value in the Realm field. The NAI Realm is a FQDN of the service provider.
c. Select the EAP Method.
Figure 63: Realm Configuration
Configure an NAI Realm list for each hotspot as follows:
• Add all realms that can authenticate the logon credentials or certificate credentials of a mobile
device, including the realms of all roaming partners that are accessible from the hotspot AP.
Include the realm of the home SP.
• Add a realm for the PLMN ID. This is the cellular network identity based on public land mobile
network (PLMN) information.
• You can configure the EAP method list to support devices that do not know the EAP methods
that are being used by a given service provider.
Hotspot
Configure
236 Extreme Campus Controller User Guide for version 5.46.03