User's Guide

Table Of Contents

When a non-root AP is incorrectly conﬁgured in a mesh network, it can become stranded. To recover a

stranded AP, reconnect to the Management Port through the wired Ethernet.

Note

Mesh device settings are supported at the Proﬁle level or conﬁgured as an override for a

speciﬁc AP.

Related Topics

Conﬁgure a Mesh Point Network on page 230

Mesh Point Network Settings on page 230

Advanced Conﬁguration and Mesh Device Settings on page 126

Mesh Point Network Diagram on page 100

Advanced Setting Overrides on page 196

Conﬁgure a Mesh Point Network

1. Conﬁgure the mesh point.

Go to Conﬁgure > Networks > Mesh Points > Add and conﬁgure the Mesh Point Network Settings.

2. Associate the mesh point network with the device group conﬁguration Proﬁle.

a. Go to Sites, and select a site.

b. Select the Device Groups tab, and select a speciﬁc device group.

c. Next to the Proﬁle ﬁeld, select .

d. Select the Mesh Points tab, and select the mesh point network for a single radio.

Note

The access points are limited to one mesh point. Multiple radios can be conﬁgured for a

single mesh point.

3. Select Advanced and conﬁgure the Mesh Device Settings in the conﬁguration Proﬁle. See Advanced

Conﬁguration and Mesh Device Settings on page 126.

Note

Mesh device settings are supported at the Proﬁle level or conﬁgured as an override for a

speciﬁc AP.