User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Table 59: Advanced Switch Settings (continued)
Field Description
SNMP Configuration You can configure SNMP for the individual switch or for the full
Extreme Campus Controller. For more information, see SNMP
Configuration on page 371.
Switch Mode Toggle between Switch CLI-Mode and Switch GUI-Mode.
• Select Change to GUI-Mode to provide CLI access under
switch Monitoring for troubleshooting purposes. For more
information, see Troubleshoot a Switch Using the CLI on
page 98.
• Select Change to CLI-Mode to provide CLI access under
switch Configuration to modify the switch configuration.
Note: The Troubleshooting tab and CLI access is not
available under switch Monitoring when the switch is in CLI-
Mode.
Related Topics
Advanced Setting Overrides on page 196
IP Address Assignment on page 204
Access the Switch CLI
Extreme Campus Controller allows access to an ExtremeXOS switch CLI for troubleshooting and manual
configuration. Switch CLI access is available in two modes:
• GUI-Mode. Provided for troubleshooting using CLI Show commands.
This is the default mode for the switch. For more information on troubleshooting an ExtremeXOS
switch, see Troubleshoot a Switch Using the CLI on page 98.
• CLI-Mode. Provided for switch configuration from the command line interface.
Access CLI-Mode from the Switch Advanced Settings page.
Important
Switching Between GUI and CLI Mode
• Switching to CLI-Mode is not service disrupting:
◦ CLI script runs against the switch.
◦ Cloud connector client saves switch configuration to a file.
◦ Extreme Campus Controller uploads and stores the configuration file in Redis.
• Switching to GUI-Mode is service disrupting:
◦ GUI-Mode is the default mode for a switch. When you change to CLI-Mode, and then
back to GUI-Mode, the switch is reset to factory settings and configured based on the
defaults for the switch model and the site configuration.
To access the switch CLI-Mode:
1. Go to Configure > Devices > Switches and select an ExtremeXOS switch.
2. Select Advanced.
Switches
Configure
218 Extreme Campus Controller User Guide for version 5.46.03