User's Guide

Table Of Contents

Conﬁgure a Switch

The information that displays on the Switch Conﬁguration page depends on the Switch Mode. By

default, switches are in GUI-Mode. To conﬁgure an ExtremeXOS switch through the CLI, you can place

the switch in CLI-Mode. For more information, see CLI - Mode Advanced Settings on page 219.

Note

CLI-Mode support is limited to ExtremeXOS switches.

To access the switch conﬁguration page:

1. Go to Conﬁgure > Devices > Switches and select a switch (not the check box).

For switches that are not in CLI-Mode, Extreme Campus Controller displays a list of ports on the

Switch Conﬁguration page. From the conﬁguration page, create LAG groups and select the Admin

state, Port Function, and PoE of each port.

For each port, the following information is displayed:

• Admin State

• Name

• Alias Function

• Speed

• Neighbor

• LAG Members

• PoE

2. Select one or more ports from the list. Then, set the Admin State, Port Function, and PoE options to

On or O. Select Apply after each selection.

Switch in CLI-Mode:

After placing an ExtremeXOS switch in CLI-Mode, the Switch Conﬁguration page display is limited to

the following buttons:

• Activate Console. Opens a remote console for a live SSH console session.

• Backups. Displays a list of switch conﬁguration backup ﬁles. From this list you can view a ﬁle or

restore a conﬁguration from a backup ﬁle.

• Create Backup. Create a backup ﬁle of the switch conﬁguration.

• Advanced. In CLI-Mode, switch advanced settings are limited to changing the switch mode. From

here you can select Change to GUI-Mode.