User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
◦ Radio 2 is enabled only if one or more antennas are configured in Group 2.
Table 56: Radio Modes AP310e/AP360e
Mode Radio 1 Radio 2
1 2.4 GHz trac forwarder 5 GHz trac forwarder
2 2.4 GHz/5 GHz sensor 5 GHz trac forwarder
3 5 GHz trac forwarder (channels 36-64) 5 GHz trac forwarder (channels 100-165)
Sensor 2.4 GHz sensor 5 GHz sensor
Figure 56: AP310e/AP360e Antenna Professional Install
Related Topics
Add APs on page 190
AP410e Professional Install Settings
The AP410e is an indoor AP with external antennas. The AP410e has the following antenna layout:
• Radio 1 and Radio 2 share ports 1 and 2
• Radio 2 uses ports 3 and 4
• Radio 3 uses ports 5 and 6
• IoT radio uses port 7 (not configurable)
The default value for Radios 1-3 is “No Antenna”, and the default value for the IoT radio is “Internal."
The ports are grouped as follows. Each port in the group must be configured with the same antenna
model:
• Group 1 — Ports 1 through 4
Configure
Access Points
Extreme Campus Controller User Guide for version 5.46.03 207