User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Table 53: Advanced AP Setting Overrides (continued)
Field Description
Poll Timeout Specifies the amount of time, in seconds, to wait for a response
from the appliance before rebooting. The value range is from 3
to 600 unless the controller is in an availability pair without fast
failover enabled. The default value is 3.
You can configure this setting for all APs in a device group from
the device group Advanced Settings dialog. And, you can
override the device group setting for an individual AP from
here.
FA Auth Key Configure custom Fabric Attach Authentication Keys up to 32
characters in length. Extreme Networks products oer a default
FA AUTHENTICATION-KEY built-in. You can also configure a
custom key here. When a custom key is not configured, the
default key is used. The following special characters are not
supported: {? <tab> \ “ `}
Note: Supported on AP3xx, AP4xx, and AP5xx models.
You can configure this setting for all APs in a device group from
the device group Advanced Settings dialog. And, you can
override the device group setting for an individual AP from
here.
LED Status You can configure LED Status for all APs in a device group from
the device group Profile Advanced settings. You can also
override LED Status for an individual AP from here. Valid values
are:
O
LEDs do not light.
Locate
LEDs blink so you can locate the AP.
Normal
Default mode for all APs. Identifies the AP status during the
following processes:
• registration
• power on
• boot
Note: The value Solid has been deprecated in Extreme
Campus Controller version 5.26.02. If Solid was previously
configured, this value is mapped to Normal with the
Extreme Campus Controller version 5.26.02 upgrade.
WLAN You can override the radio WLAN assignments for a specific
AP. The result is that the AP has a unique radio WLAN
assignment, plus port and IOT assignments, and policy
definitions that are defined in the configuration Profile. The AP
must be part of a device group, but you can override the WLAN
per AP in order to enable or disable a selected network. This
can be useful for testing and troubleshooting purposes. See
WLAN Override on page 201.
Access Points Configure
198 Extreme Campus Controller User Guide for version 5.46.03