User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Table 41: Advanced Configuration Profile Settings (continued)
Field Description
PEAP User Name and Password Ability to configure the PEAP (Protected Extensible
Authentication Protocol) user name and password for all
devices in a device group or for a specific device override. Used
to pre-provision devices for authorization to connect to the
network. Credential and Certificate installation procedures are
supported for Wi-Fi 6 APs, AP39xx series APs, and the SA201
Adapter.
You can override the configuration Profile setting for one or
more individual APs from the Advanced > Overrides dialog for
the selected AP.
Client Bridge
Roaming RSS threshold [dBm]
Determines when the client bridge AP scans to find a better
infrastructure AP. Valid range: from -128 to -40. Default value is
-70. A scan is triggered when one or more of the following
criteria is met:
• When the infrastructure AP RSS value is less than the
configured RSS Threshold.
• When the poll of the infrastructure AP is lost for one
second.
Note: When a WLAN is configured on the client bridge AP, a
scan is triggered whenever the poll of the infrastructure AP
is lost, regardless of the RSS Threshold.
You can override the configuration Profile setting for one or
more individual APs from the Advanced > Overrides dialog for
the selected AP.
Smart Poll Reports link stability between the AP and a selected target
(typically the appliance). Select Enable to enable the report
feature and configure the following settings:
• Smart Poll — Disable/Enable. The default value is Disable.
• Smart Poll Interval in seconds. Valid values are:
◦ 5
◦ 30
◦ 60
◦ 300 (5 minutes) Default value
• Smart Poll Target — Identifies the target. Select
to add a
target address. Enter up to 10 IP addresses or Fully-
Qualified Domain Names (FQDN). Extreme Campus
Controller validates the address.
• Smart Poll Deadline — Deadline for the poll response in
seconds. If the response is not received within the specified
deadline, the poll status is failed.
You can override the configuration Profile setting for one or
more individual APs from the Advanced > Overrides dialog for
the selected AP.
Related Topics
Advanced AP Settings on page 195
View Events Log on page 338
Add or Edit a
Configuration Profile Configure
162 Extreme Campus Controller User Guide for version 5.46.03