User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Figure 47: Configuration Profile with Client Bridge Configuration
Note
A Client Bridge AP will not associate to the infrastructure network with authentication
types Open or WPA2-Personal (PSK) in combination with captive portal. These scenarios
require user interaction.
Note
The Client Bridge network and the infrastructure AP network must match on the same
radio. On the Client Bridge AP, if the 2.4 GHz radio is configured as Client Bridge, the
infrastructure AP must broadcast that network on a 2.4GHz radio.
6. From the configuration Profile Advanced settings, the GE2 Port Function is automatically set to
Client after configuring the Client Bridge radio.
Note
• Ports on the Universal APs are labeled with the prefix ETH.
• When Client Bridge is configured on a single interface AP, the single interface is used as
the client port, not as an uplink, and you will not see the GE2 Port Function.
7. Save the configuration Profile.
8. If you are planning to connect the end-system to the Client Bridge AP through the GE2 port, edit the
configuration Profile again.
Add or Edit a
Configuration Profile Configure
132 Extreme Campus Controller User Guide for version 5.46.03