User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
4. To delete a site, select Delete.
A delete confirmation message displays. Select OK.
Related Topics
Site Parameters on page 118
Floor Plans on page 24
Site Location on page 120
Device Groups on page 21
RADIUS Configuration for Switches Per Site on page 119
Advanced Tab on page 183
RADIUS Configuration for Switches Per Site
Extreme Campus Controller supports direct access from a switch to an external RADIUS server within
the site configuration. You can associate up to two RADIUS servers for accounting and two RADIUS
servers for authentication.
Note
When using 200 Series switches, only one accounting server is supported.
You must first configure the RADIUS servers before you can associate them to switches in a site
configuration.
1. Configure each RADIUS server.
Go to Onboard > AAA > RADIUS Servers.
2. Associate the RADIUS servers to the switches within the site configuration.
a. Go to Configure > Sites and select a site.
b. Select the Switches tab.
c. Configure the following parameters:
MSTP
Enable the MSTP (Multiple Spanning Tree Protocol) to optimize load balancing.
AAA Policy
Refer to external RADIUS servers directly without proxy by NAC. For configuration steps, see
Configure AAA Policy on page 289.
Switches
Check the switches that are associated with the site.
Related Topics
AAA RADIUS Authentication on page 288
Configure AAA Policy on page 289
Switch Port Configuration on page 215
Configure
Modifying Site Configuration
Extreme Campus Controller User Guide for version 5.46.03 119