User's Guide

Table Of Contents

6. Go back to each device group and associate the conﬁgured networks and the deﬁned roles by

editing the assigned conﬁguration Proﬁle. Alternatively, you can associate the Proﬁle with the

network or policy deﬁnition during the initial conﬁguration of the network or role. For more

information, see Associated Proﬁles on page 124.

7. Install and add devices.

Access Points and switches are automatically added to an Extreme Campus Controller conﬁguration

via the cloud-connector when the DHCP and DNS prerequisites have been met. However, you can

use the Add function to pre-provision any AP or switch before they connect, allowing them to be

added to the correct site.

AP discovery behavior depends on your site conﬁguration and whether or not you are using

adoption rules:

• If you have a device group with a valid proﬁle and a valid adoption rule, the APs are automatically

added to the proper device group.

• If you have a device group with a valid proﬁle, but no adoption rules, the APs are listed in the

device group where you can manually add them to the group.

• If you do not have a valid device group for the AP, the AP is listed on the Devices list with an In-

Service Trouble status. After a valid device group is created, the AP is automatically listed within

the device group, where you can manually add it to the group.

8. (Optional) Add one or more ﬂoor plans for each site.

9. Set up access control and captive portal.