User's Guide

Related Topics
Overview Dashboard on page 31
Client Access Lists
Clients on a Deny list are denied network access. Clients on an Allow list are granted network access.
Use these lists to create a subcategory of users that are set apart from the larger group by their access
privileges. The client MAC address is used to add the client to a specific list.
You have the option to configure access lists per site or for all networks being broadcast by any AP
managed by Extreme Campus Controller or by an Extreme Campus Controller availability pair.
Note
Configure a Deny list or an Allow list, but not both. To filter specific users by MAC address,
configure Access Control rules.
Related Topics
Global Client Access Lists on page 106
Site Client Access Lists on page 106
Managing Access Control Rules on page 322
Global Client Access Lists
To set up a global list for all Extreme Campus Controller networks:
1. Go to Monitor > Clients and select Allow/Deny List.
This displays the list Mode for your network and a list of MAC addresses.
2. Select Allow List or Deny List.
The Mode you select applies to the entire network.
3. To add MAC addresses to the list, select Add and enter a MAC address for the client.
4. To delete a MAC address from the list, select the MAC address from the list, then select Delete.
To select the entire list, select the MAC Address check box.
Related Topics
Client Access Lists on page 106
Site Client Access Lists on page 106
NEW!
Site Client Access Lists
The selected Access List Mode applies to all access points in the site. The access list is stored on the AP
and shared across the site. A client MAC address on the site Deny List, cannot connect to a network
broadcast by any AP associated with the site.
To set up an access list for clients associated with a site:
1. Go to Configure > Sites and select a site.
2. Select Allow List/Deny List tab.
3. Select Use Site Allow/Deny List.
Client Access Lists
Monitor
106 Extreme Campus Controller User Guide for version 5.46.03