User's Guide
Table Of Contents
- Table of Contents
- Preface
- Welcome to Extreme Campus Controller
- Dashboard
- Monitor
- Sites List
- Device List
- Access Points List
- Smart RF Widgets
- Switches List
- Networks List
- Clients
- Policy
- Configure
- Network Configuration Steps
- Sites
- Add a Site
- Modifying Site Configuration
- Site Location
- Adding Device Groups to a Site
- Add or Edit a Configuration Profile
- Associated Profiles
- Associated Networks
- Mesh Point Profile Configuration
- Configure Client Bridge
- Understand Radio Mode
- Radio as a Sensor
- Advanced AP Radio Settings
- VLAN Profile Settings
- AirDefense Profile Settings
- ExtremeLocation Profile Settings
- IoT Profile Settings
- Positioning Profile Settings
- Analytics Profile Settings
- RTLS Settings
- Advanced Configuration Profile Settings
- Configuring RF Management
- Configuring a Floor Plan
- Advanced Tab
- Devices
- Networks
- Policy
- Automatic Adoption
- ExtremeGuest Integration
- AAA RADIUS Authentication
- Onboard
- Onboard AAA Authentication
- Manage Captive Portal
- Manage Access Control Groups
- Access Control Rules
- Tools
- Administration
- System Configuration
- Manage Administrator Accounts
- Extreme Campus Controller Applications
- Product License
- Glossary
- Index
Figure 40: Navigation Buttons
• Zoom in and out using the zoom buttons.
Figure 41: Zoom Buttons
• To center the diagram, select .
• To refresh the diagram, select
.
• To jump to the Mesh Point Network Configuration Settings, select .
Related Topics
Mesh Point Network Settings on page 230
Mesh Point Network on page 228
Configure a Mesh Point Network on page 230
Advanced Configuration and Mesh Device Settings on page 126
Mesh Point Profile Configuration on page 125
Clients
The Clients tab displays a list of clients in your network. Use this information to understand client status,
access roles, and associated APs. From the client list, you can add clients to and remove clients from
access lists.
From the client Actions button, you can delete and disassociate clients, re-authenticate clients, and
move clients into and out of groups.
Highlights on the Clients List:
• IP Address — The IP Address field displays the IPv4 address and indicates when there is up to three
IPv6 addresses. Hover over the IP Address field to view the full IPv6 address. You also have the
option to display the IPv6 addresses in a separate field.
• RSS (dBm) — Received Signal Strength Indicator is the estimated power level that a client device is
receiving from the associated access point.
• Spatial Stream — Number of MIMO streams supported by each client. Use this information to inform
your decisions about hardware purchases and decisions about network configuration.
• Capabilities — Client protocol capabilities. Indicates which protocol capabilities the client supports.
Valid values are:
◦ PMF (Protected Management Frame) — PIM (Protocol Independent Multicast) Flooding
Mechanism.
◦ RRM — Radio Resource Management
Clients
Monitor
104 Extreme Campus Controller User Guide for version 5.46.03