Release Notes

Extreme Campus Controller Customer Release Notes
2/17/2022 P/N: 9036946-09 Subject to Change Without Notice Page: 11 of 21
F0615-O
Known Restriction or Limitation
I.D
AP310 models are not currently supported by ExtremeLocation
TM
. Do not enable
ExtremeLocation settings in the configuration Profile for an AP310 device group.
Doing so may have a negative impact on AP performance.
ECA-1620
For Extreme Campus Controller configured for authentication of administrators over
RADIUS server, the GUI responsiveness may be slow, possibly over 30 seconds if
target server(s) are unavailable/unreachable at login time. If outage is extensive,
system will eventually timeout to validate against local credentials when provisioned.
ECA-1396
For High-Availability installations, on systems configured with RADIUS Accounting or
Smart RF enabled, clients (end-systems) may experience a momentary disconnect
during the upgrade process (maintenance window).
Users immediately reconnect to the available infrastructure, so impact is negligible.
For smoother session availability with fast-failover during a failover event, it is
recommended to not run these options. This issue is being investigated and will be
addressed in a future release.
ECA-1264
Upgrade failure will occur when using special characters (escape back slash) in
topology.
ECA-466
In SmartRF mode, the AP510 power may temporarily drop to 0dBm and returns to
4dBm.
ECA-469
With on-air-busy channel conditions, it is possible for the ACS not to produce the
expected results. In this instance, perform manual channel selection.
ECA-528
Widgets do not show tooltips for lower and upper values. This issue will be addressed
in a future release.
ECA-567
Firmware for ExtremeWireless AP3900 series access points does not currently
support Smart RF. No Smart RF data is displayed.
ECA-1484
Interaction with ExtremeManagement Center – Management of Extreme Campus
Controller by ExtremeManagement Center will be enhanced over time with the
roadmap. ExtremeManagement Center v8.5.5 is the minimum release base for
integration. Version 8.5.5 provides recognition of an Extreme Campus Controller and
representation of Wireless Clients and managed Access Points included in the
Wireless tab.
Additional integration will be delivered in upcoming releases. ExtremeManagement
Center 8.5.5 is the current recommended minimum release.
Info
Several old Intel clients (i.e. Intel dual band Wireless AC – 7260) if they are using old
drivers are NOT seeing BSSID / SSID advertising 11x capability. This is a client issue
(forward compatibility). Other older clients may have this issue.
See:
[https://www.intel.com/content/www/us/en/support/articles/000054799/network-and-i-
o/wireless-networking.html|http://example.com]
See KB:
[https://gtacknowledge.extremenetworks.com/articles/Solution/AP510-Unable-to-see-
the-SSID-on-my-laptop|http://example.com]
NB – The client driver update must be done from Intel\drivers' site because the
Windows update reports that the client is running the latest driver.
If the client driver cannot be controlled (in a BYOD environment), then the AP radios
must be configured on a/n/ac (disable ax) until all clients will upgrade to the latest
driver.
Info
Default router/gateway should be configured with a next-hop associated with one of
the physical interfaces. Pointing the default route to the Admin interface will lead to
issues because access points will not get the correct services from the data plane.
Info