Installation Guide

2. Set IP address to 10.0.0.1.
3. Press Enter.
4. Set the Netmask value to 255.255.255.0.
5. Press Enter.
6. Press Enter again to set the default VLAN.
The tagged frames command is displayed.
7. Press Enter to keep the default tagged frames value to No.
8. To enable management on the interface, press Enter to select the default value, Yes.
9. Press Enter to enable device registration, and select the default value yes.
The updated Data Port Settings is displayed.
10. Press Enter to accept the changes and keep the data port values you have chosen.
The Data Port Interface is now set. The CLI navigates to the Current Host Attributes Settings screen.
Current Host Attributes Settings
About This Task
To set up the host attributes:
Procedure
1. Press Enter to change the host attributes.
2. Press Enter to type the host name.
3. Type Y to setup a dedicated Admin port for out-of-band management.
The default option is no. A note is displayed that the Admin port does not allow device registration.
4. Type the IP address in the xx.xx.xx.xxx format to set up the IP address for the Admin port.
5. Press Enter to accept the default IP netmask for the Admin port.
6. Press Enter to accept the default domain name for the appliance.
The default domain name is extremenetworks.com.
7. Press Enter to
configure the primary DNS server.
8. Type another IP address in the xx.xx.xx.xxx format to set up the primary DNS server IP address.
9. Press Enter.
The default option to set up a secondary DNS server is no.
10. Press Enter to accept the default option.
The updated host attributes settings are displayed.
11. Press Enter to accept the changes you have made.
The Current Global Default Gateway Settings CLI is displayed.
Current Global Default Gateway Settings
About This Task
The global default gateway may be on any Admin or data port topology or subnet.
Virtual Appliance
Configuration Current Host Attributes Settings
VE6120H Virtual Appliance Installation Guide for version 4.76.02 29