Installation Guide

The configuration wizard prompts with a set of Yes or No questions. The default value is indicated in
parenthesis. To accept the default value, select Enter.
For more information about using the Basic Configuration Wizard, see Set Up the Virtual Appliance
using the Basic Configuration Wizard.
Set Up the Virtual Appliance Using the Basic Configuration Wizard
About This Task
After you log into the Basic Configuration Wizard CLI, you will be able to set up the virtual appliance
using a set of Yes or No commands. When you log into the Basic Configuration Wizard CLI, you will be
prompted to change the password.
Procedure
1. To begin admin password setup, press Enter.
The Admin password Configuration screen is displayed.
a. To change the admin password, press Enter.
b. Type the new password for the admin account.
Note
The password must be between 8–24 characters.
c. Repeat the new admin account password and press Enter.
The password is accepted if there is a match.
d. Press Enter to accept the changes.
The AP access password screen is displayed.
2. Type a new password to reset the AP access password.
Note
The password must be between 5–30 alphanumeric characters and can include period,
dash, underscore, and space.
3. Retype the AP access password.
4. Press Enter.
Your AP access password is now reset and the Current Data Port Settings CLI is displayed.
Current Data Port Settings
About This Task
Once you configure the admin password, you will be prompted to set up the Current Data Port
Settings.
Procedure
1. Press Enter to select Port1.
Port1 is the default port.
Set Up the Virtual Appliance Using the Basic
Configuration Wizard Virtual Appliance Configuration
28 VE6120H Virtual Appliance Installation Guide for version 4.76.02