Installation Guide
Table Of Contents
- Table of Contents
- Preface
- Virtual Appliance Deployment
- Virtual Appliance Configuration
- Configure Virtual Switches for the Virtual Appliance
- Shut Down and Restart a Virtual Machine
- Index
4. Select Settings from the Action menu.
5. From Hardware, select one of the following adapters:
• MgmtAdapter
MgmtAdapter is the network the VE6120H management port is expecting to connect to. That
network should be mapped to a virtual switch that will be used for management
trac.
• PhysAdapter1
PhysAdapter1 is the network that the VE6120H Port1 expects to use. That network should be
mapped to a virtual switch on the host that will carry trac between the VE6120H and the
access points.
• PhysAdapter2
PhysAdapter2 is the network that the VE6120H Port2 expects to use. That network should be
mapped to a virtual switch on the host that will carry trac between the VE6120H and the
access points.
Note
Do not use the bandwidth management feature since the appliance performs CoS
enforcement on all trac that egresses the appliance.
Configure the Network Adapter Virtual Appliance Deployment
22 VE6120H Virtual Appliance Installation Guide for version 4.76.02