Specifications

Clarifications, Known Behaviors, and Resolved Issues

EPICenter Release Note

Adding SNMP v3 devices fails

In some cases SNMP v3 devices may fail to be added to the database, and a “Time Synchronization

failure could have occurred” error appears in the log. Restarting the EPICenter server will correct the

problem. (PD3-24472462)

Stacking Port Link information displayed incorrectly on two-switch ExtremeXOS

stacking devices

Information in the Stacking Port Link tab is displayed incorrectly on an ExtremeXOS stacking device

that contains only two switches. The Stacking Port Link information is displayed correctly if the

stacking device contains more than two switches. (PD3-142240641)

SNMP Timeout when manually synchronizing a device with many VLANs

If you attempted to manually synchronize a device that has a large number of VLANs (more than 800),

it resulted in an SNMP timeout. As a workaround, increase the default SNMP timeout value. (PD3-

173510081)

Device uptime reported as a negative number

EPICenter reported the up time for a device as a negative number of days, hours, and minutes. (PD3-

73114319)

IP/MAC Address Finder

EPICenter does not use VRs when pinging, resulting in errors on some ExtremeXOS

devices

In the IP/MAC Address Finder, EPICenter pings without using any VR, thus using VR-default only. If

some ExtremeXOS switches are in VR-mgmt, this results in a packet transmit error. (PD3-90286092)

With multiple connections between two switches, incorrect port, MAC Addresses, and

IP addresses are reported

If there are multiple connections between two switches such that there are multiple FDB entries with the

same MAC address, IP/MAC Address Finder will report only the first matched MAC address or IP

address and port. This occurs because the ipNetToMedia table does not contain information about

VLANs that would enable distinguishing between the entries. (PD2-242747853, PD2-77302783)

Real-Time Statistics

Hierarchical port groups are not displayed correctly in the RT Statistics applet

The Real-Time Statistics applet does not support hierarchical groups. Selecting a subgroup of a port

group is not recognized; selecting the top-level port group initially displays all ports in the group and