Specifications

Clarifications, Known Behaviors, and Resolved Issues
EPICenter Release Note
28
Configuration Manager
Downloading a config file to device fails if using SSH
Downloading a configuration file to a device running ExtremeWare fails if EPICenter attempts to use
SSH to the device. To successfully download a configuration through EPICenter, you must temporarily
disable SSH for the device. (PD3-102888481)
Changing the Diff or Config file viewer settings does not work properly
Changing the settings for the configuration file viewer or the Diff viewer does not work properly when
the client is connected to a Linux server. For the configuration viewer it will attempt to use the viewer
configured on the server; for a Diff it uses sdiff, which is available locally. (PD3-91990375)
Configuration File displayed in raw XML for ExtremeXOS devices
When viewing a configuration file from a device running ExtremeXOS, the contents of the file is
displayed in raw XML format. EPICenter should show the contents in the same format as used by the
CLI “show config” command. (PD3-64376621)
Firmware Manager
Attempting image upgrade while save is in progress causes an error
You will most often see this problem when you are using pscp or sftp. The error message is:
ScpSession: pscp: unable to open configuration.cfg: permission denied
When you have this problem, redo the task after the save is done. (PD2-137802543)
Status for SSH versions of ExtremeWare may be shown incorrectly
In the Firmware Manager’s Upgrade Wizard, the status of some SSH versions of ExtremeWare may be
shown incorrectly.
If a non-SSH version of a specific image (release/build) is already shown as General Availability, the
SSH version of that image will be shown as Obsolete when it should be shown as General Availability.
(PD3-26300275)
“Obsolete” column for device image is empty
In the Firmware Manager, the Obsolete column for device images in the right-hand side table for a
device group is always empty. (PD3-19001279)