Specifications

EPICenter 7.0 Device Support
EPICenter Release Note
13
If you have a support contract, you can download the latest versions of ExtremeWare or ExtremeXOS
from:
http://www.extremenetworks.com/go/esupport.htm.
Switch Access Requirements
EPICenter uses both SNMP and Telnet to discover and communicate with the devices on your network.
They support both SNMP v1/v2 or SNMP v3.
● SNMP must be enabled on the switch for EPICenter to discover the device, and for EPICenter to
manage the switch.
● If you use access profiles to control SNMP, Telnet and SSH access to your switches, you must ensure
that the EPICenter host’s IP address is permitted in those access profiles.
EPICenter 7.0 Device Support
With a base license, EPICenter 7.0 supports up to 250 managed devices. The Gold upgrade provides
support for up to 2000 devices, and also supports Distributed Server Mode to enable support of very
large networks. The following sections list the devices supported by EPICenter 7.0.
Extreme Networks Device Support
EPICenter 7.0 supports the following Extreme Networks devices:
ReachNXT ExtremeXOS 11.2 on the connected switch
ExtremeXOS 12.2 on the connected switch required for ReachNXT
firmware upgrade capability
BlackDiamond 6800 6.2 or later
BlackDiamond 8800 ExtremeXOS 11.1 or later
ExtremeXOS 12.0 or later for 10G4Ca Module
ExtremeXOS 12.3 or later for 8900-MSM128, 8900-10G24X-c, and
8900-G96T-c modules
BlackDiamond 8900 ExtremeXOS 12.3 or later
BlackDiamond 10808 ExtremeXOS 11.0 or later
BlackDiamond 12802 ExtremeXOS 12.0 or later
BlackDiamond 12804 ExtremeXOS 11.4 or later
BlackDiamond 20808 ExtremeXOS 12.2 or later
Table 3: Extreme Networks devices supported by EPICenter 7.0
Switches/Modules
Summit switches:
Summit1i /1iSX Summit24e3 Summit 300-24 SummitPx1*
Summit5iTX/LX/SX Summit48i/48Si Summit 300-48 Summit WM 100/1000
Table 2: ExtremeWare/ExtremeXOS versions supported by EPICenter 7.0
Extreme Switch Platform ExtremeWare Versions Supported