Installation manual

Chapter 1: Introduction
Extreme Networks EAS 200-24p Switch Hardware Installation Manual
14
Ports
The switch features the following port specifications:
● EAS 200-24p: 20-Port 10/100/1000Base-T with 4 Combo Copper/SFP PoE ports, L2 management
switch.
● All the switches are equipped with one RJ-45 Console port (a special console cable with a DB9
interface is provided to connect the switch to a PC).
Front Panel Components
The front panel of the switch consists of LED indicators for Power, Console, Fan, and for Link/Act for
each port on the switch including SFP port LEDs.
Figure 1: Front Panel View of the EAS 200-24p
LED Indicators
The switch front panel presents LED indicators for Power, Console, Fan, and Link/Act indicators for all
ports including the Gigabit Ethernet ports. The switch is equipped with an additional PoE light, to
indication whether the ports are running in Power over Ethernet mode.
Figure 2: LED Indicators for the EAS 200-24p
LED Description
Power This LED will light green after powering the switch on to indicate the ready state of the
device. The indicator is dark when the switch is no longer receiving power (i.e. powered
off).
Console This LED will blink green during the Power-On Self Test (POST). When the POST is
finished, the LED goes dark. The indicator will light steady green when a user is logged in
through the console port.
Fan This LED blinks red when a fan fails. No light indicates all fans are working normally.