Installation manual

Chapter 1: Introduction
Extreme Networks EAS 200-24p Switch Hardware Installation Manual
12
● IEEE 802.1p Priority Queues
● IEEE 802.3ad Link Aggregation Control Protocol for up to 32 groups per device, eight ports per
group
● IEEE 802.1X Port-based and Host-based Access Control
● IEEE 802.1Q VLAN
● IEEE 802.1D Spanning Tree, IEEE 802.1w Rapid Spanning Tree and IEEE 802.1s Multiple Spanning
Tree support
● Jumbo frame to 13K Bytes
● Access Control List: Ingress ACL up to 6 profiles and 256 rules and Egress ACL up to 4 profiles and
128 rules
● Single IP Management
● Access Authentication Control utilizing TACACS, XTACACS, TACACS+, and RADIUS protocols
● Power saving mode
● Simple Network Time Protocol (SNTP)
● System Log
● Maximum packet forwarding rate 65.48 million packets per second
● High performance switching engine performs forwarding and filtering at full wire speed up to
48Gps
● Full- and half-duplex for all ports. Full duplex allows the switch port to simultaneously transmit and
receive data. It only works with connections to full-duplex-capable end stations and switches.
Connections to a hub must take place at half-duplex.
● Unicast, broadcast, and multicast storm control
● Loopback Detection (LBD) v4.0 Trap
● Efficient self-learning and address recognition mechanism enables forwarding rate at wire speed
● Address table: up to 16 K
● Packet buffer memory of up to 2 MByte
● VLAN Trunking
● Private VLAN
● Maximum of 4K VLAN groups
● 802.1Q (2005 edition)
● GVRP for 4K VLAN (255 dynamic) groups
● Voice VLAN by MAC address
● VLAN tagging based on PVID
● Up to 1024 MAC-based VLAN entries
● IGMP Snooping v1/v2 (IGMPv3 Awareness)
● MLD Snooping v1 (MLDv2 Awareness)
● Up to 1024 IGMP/MLD snooping groups
● SNMP v1/v2/v3
● SNMP over IPv6
● Secure Sockets Layer (SSL) v1/v2/v3
● Secure Shell (SSH) v2
● Port Mirroring