Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
LLDP Folder
Extreme Networks EAS 100-24t Switch Software Manual
91
To view this window, click L2 Features > LLDP > LLDP Dot1 TLVs Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
LLDP Dot3 TLVs Settings
This window is used to configure an individual port or group of ports to exclude one or more IEEE
802.3 organizational specific TLV data type from outbound LLDP advertisements.
Parameter Description
From Port/To Port Use the pull-down menu to select a range of ports to be configured.
PVID Use the drop-down menu to enable or disable the advertise PVID.
Protocol VLAN ID Use the drop-down menu to enable or disable the advertise Protocol VLAN ID.
VLAN Name Use the drop-down menu to enable or disable the advertise VLAN Name.
Protocol Identity Use the drop-down menu to enable or disable the advertise Protocol Identity.