Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
LLDP Folder
Extreme Networks EAS 100-24t Switch Software Manual
89
LLDP Port Settings
To view this window, click L2 Features > LLDP > LLDP Port Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Parameter Description
From Port/To Port Use the pull-down menu to select a range of ports to be configured.
Notification Use the pull-down menu to Enable or Disable the status of the LLDP
notification. This function controls the SNMP trap, however it cannot
implement traps on SNMP when the notification is disabled.
Admin Status This functions controls the local LLDP agent and allows it to send and receive
LLDP frames on the ports.This option contains Tx, Rx, Tx and Rx or Disabled.
Tx: the local LLDP agent can only transmit LLDP frames.
Rx: the local LLDP agent can only receive LLDP frames.
Tx and Rx: the local LLDP agent can both transmit and receive LLDP frames.
Disabled: the local LLDP agent can neither transmit nor receive LLDP frames.
The defaut value is Tx and Rx.
Subtype This read-only field displays IPv4, the type of the IP address.
Action Used to Enable or Disable the advertise management address function base
port.
Address The address must be the management IP-address. For multi IP-addresses,
you can enter any IP or create a new IP interface that you want to add.