Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 3: Layer 2 Features
Extreme Networks EAS 100-24t Switch Software Manual
86
Multicast Forwarding Settings
To view this window, click L2 Features > Forwarding & Filtering > Multicast Forwarding Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Click on the Edit button to re-configure a specific entry.
Click on the Delete button to remove the selected entry.
Click on the Clear All button to clear all the entered data from the fields.
Click on the All button to select all the ports for this configuration.
Multicast Filtering Mode
Users can configure the multicast filtering mode.
Parameter Description
VLAN ID (1-4094) The VLAN ID of the VLAN to which the corresponding MAC address belongs.
MAC Address The MAC address that will be added to the multicast forwarding table.
Port Settings Allows the selection of ports that will be members of the static multicast group.
The options are:
None - No restrictions on the port dynamically joining the multicast group.
When None is chosen, the port will not be a member of the static multicast
group.
Egress - The port is a static member of the multicast group.
Click All to choose either all of the ports selected as None or all of the ports
selected as Egress. Click Clear All to clear all the settings at the top of this
window.