Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
LACP Port Settings
Extreme Networks EAS 100-24t Switch Software Manual
67
Click on the Apply button to accept the changes made.
Click on the Clear All button to clear all the entered data from the fields.
Click on the Add button to add a new entry.
LACP Port Settings
This window is used to create port trunking groups on the Switch for LACP type. The user may set
which ports will be active and passive in processing and sending LACP control frames.
To view this window, click L2 Features > LACP Port Settings:
In this window, the following parameters can be configured:
Flooding Ports These ports are designated for flooding broadcast, multicast, and DLF (unicast
Destination Lookup Fail) packets from the CPU in a trunk group. The port is
defined by software and doesn’t actually exist in the hardware.
Parameter Description
From Port/To Port A consecutive group of ports may be configured starting with the selected
port.
Parameter Description