Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 3: Layer 2 Features
Extreme Networks EAS 100-24t Switch Software Manual
58
Q-in-Q Settings
To view this window, click L2 Features > Q-in-Q > Q-in-Q Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Parameter Description
Q-in-Q Global Settings Click the radio button to enable or disable the Q-in-Q Global Settings.
From Port/To Port A consecutive group of ports that are part of the VLAN configuration starting
with the selected port.
Role The user can choose between UNI or NNI role.
UNI – To select a user-network interface which specifies that communication
between the specified user and a specified network will occur.
NNI – To select a network-to-network interface specifies that communication
between two specified networks will occur.
Outer TPID (hex: 0x1 -0xffff) The Outer TPID is used for learning and switching packets. The Outer TPID
constructs and inserts the outer tag into the packet based on the VLAN ID and
Inner Priority.
VLAN Translation Enable or disable VLAN Translation. This translates the VLAN IDs carried in
the data packets received from private networks into those used in the
Service Provider’s network. The default is Disabled. Note: To use this function,
Trust CVID must also be enabled.