Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 3: Layer 2 Features
Extreme Networks EAS 100-24t Switch Software Manual
54
6 Before Q-in-Q VLANs are enabled, users need to disable STP and GVRP manually.
7 All packets sent from the CPU to the Access ports must be untagged.
802.1Q Static VLAN
This window lists all previously configured VLANs by VLAN ID and VLAN Name.
To view this window, click L2 Features > 802.1Q Static VLAN:
To create a new 802.1Q VLAN entry, click the Add/Edit VLAN tab at the top of the window. A new tab
will appear, as shown in the first figure on the next page, to configure the port settings and to assign a
unique name and number to the new VLAN.
To edit an existing 802.1Q VLAN entry, click the Edit button next to the corresponding VLAN entry
above. A new tab will appear, as shown in the second figure on the next page.
See the table on the next page for a description of the parameters of the 802.1Q Static VLAN window’s
Add/Edit VLAN tab.
NOTE
After all IP interfaces are set for configurations, VLANs on the Switch can be routed without any additional
steps.