Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
SNMP Settings Folder
Extreme Networks EAS 100-24t Switch Software Manual
45
To change the Engine ID, enter the new Engine ID in the space provided and click the Apply button.
SNMP Trap Configuration
The following window is used to enable and disable trap settings for the SNMP function on the Switch.
To view this window for configuration, click Configuration > SNMP Settings > SNMP Trap
Configuration:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
RMON
Users can enable and disable remote monitoring (RMON) status for the SNMP function on the Switch.
Parameter Description
SNMP Trap Specifies to enable or disable SNMP Traps.
SNMP Authentication Traps Specifies to enable or disable SNMP Authentication Traps.
SNMP Link Change Traps Specifies to enable or disable SNMP Link Change Traps.
From Port ~ To Port Specifies the list of port used for this configuration.
State Specifies to enable or disable the SNMP LinkChange Traps port settings
state.