Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 2: Configuration
Extreme Networks EAS 100-24t Switch Software Manual
44
SNMP Host Table
Use the SNMP Host Table window to set up SNMP trap recipients. To configure SNMP Host Table
entries, click Configuration > SNMP Settings > SNMP Host Table
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
SNMP Engine ID
The Engine ID is a unique identifier used for SNMP V3 implementations. This is an alphanumeric string
used to identify the SNMP engine on the Switch.
To display the Switch's SNMP Engine ID, click Configuration > SNMP Settings > SNMP Engine ID:
In this window, the following parameters can be configured:
Parameter Description
Host IP Address Type the IP address of the remote management station that will serve as the
SNMP host for the Switch.
User-based Security Model SNMPv1 - Specifies that SNMP version 1 will be used.
SNMPV2c - Specifies that SNMP version 2 will be used.
SNMPV3 - To specify that the SNMP version 3 will be used.
Security Level NoAuthNoPriv – To specify a NoAuthNoPriv security level.
AuthNoPriv - To specify an AuthNoPriv security level.
AuthPriv - To specify an AuthPriv security level.
Community String/ SNMPv3
User Name
Type in the community string or SNMPv3 user name as appropriate.
Parameter Description
Engine ID Specifies the SNMP Engine ID used here.