Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 2: Configuration
Extreme Networks EAS 100-24t Switch Software Manual
42
SNMP User Table
This window displays all of the SNMP User's currently configured on the Switch and also allows you to
add new users.
To view this window, click Configuration > SNMP Settings > SNMP User Table:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Parameter Description
User Name An alphanumeric string of up to 32 characters. This is used to identify the
SNMP users.
Group Name This name is used to specify the SNMP group created can request SNMP
messages.
SNMP Version V1 - Indicates that SNMP version 1 is in use.
V2 - Indicates that SNMP version 2 is in use.
V3 - Indicates that SNMP version 3 is in use.
SNMP V3 Encryption None – Indicates that there is no SNMP V3 Encryption
Password – Indicates that there is SNMP V3 Encryption through a password
Key – Indicates that there is SNMP V3 Encryption through a key.
Auth-Protocol by Password MD5 - Indicates that the HMAC-MD5-96 authentication level will be used.
SHA - Indicates that the HMAC-SHA authentication protocol will be used.
Priv-Protocol by Password None - Indicates that no authorization protocol is in use.
DES - Indicates that DES 56-bit encryption is in use based on the CBC-DES
(DES-56) standard.
Auth-Protocol by Key MD5 - Indicates that the HMAC-MD5-96 authentication level will be used.
SHA - Indicates that the HMAC-SHA authentication protocol will be used.
Priv-Protocol by Key None - Indicates that no authorization protocol is in use.
DES - Indicates that DES 56-bit encryption is in use based on the CBC-DES
(DES-56) standard.
Password Enter a Password when SNMP V3 Encryption is enabled for Password mode.
Key Enter a Key when SNMP V3 Encryption is enabled for Key mode.