Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 2: Configuration
Extreme Networks EAS 100-24t Switch Software Manual
36
To configure the time zone settings for the Switch, click Configuration > SNTP Settings > Time Zone
Settings:
In this window, the following parameters can be configured:
Parameter Description
Time Zone and DST:
Daylight Saving Time State Use this pull-down menu to enable or disable the DST Settings.
Daylight Saving Time Offset
in Minutes
Use this pull-down menu to specify the amount of time that will constitute your
local DST offset 30, 60, 90, or 120 minutes.
Time Zone Offset from UTC
in +/- HH:MM
Use these pull-down menus to specify your local time zone's offset from
Coordinated Universal Time (UTC).
DST Repeating Settings:
Using repeating mode will enable DST seasonal time adjustment. Repeating mode requires that the DST
beginning and ending date be specified using a formula. For example, specify to begin DST on Saturday during
the second week of April and end DST on Sunday during the last week of October.
From: Which Week of the
Month
Enter the week of the month that DST will start on.
From: Day of the Week Enter the day of the week that DST will start on.
From: Month Enter the month DST will start on.
From: Time in HH:MM Enter the time of day that DST will start on.
To: Which Week of the
Month
Enter the week of the month the DST will end.
To: Day of the Week Enter the day of the week that DST will end.
To: Month Enter the month that DST will end.
To: Time in HH:MM Enter the time DST will end.