Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
SNTP Settings Folder
Extreme Networks EAS 100-24t Switch Software Manual
35
Time Settings
To configure the time settings for the Switch, click Configuration > SNTP Settings > Time Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Time Zone Settings
The following window is used to configure time zones and Daylight Savings Time settings for SNTP.
Parameter Description
Status:
SNTP State Use the radio button to select an Enabled or Disabled SNTP state.
Current Time Displays the Current Time set on the Switch.
Time Source Displays the time source for the system.
SNTP Settings:
SNTP First Server This is the IP address of the primary server the SNTP information will be
taken from.
SNTP Second Server This is the IP address of the secondary server the SNTP information will be
taken from.
SNTP Poll Interval in
Seconds (30-99999)
This is the interval, in seconds, between requests for updated SNTP
information.
Set Current Time:
Date (DD/MM/YYYY) Enter the current date in day, month and year to update the system clock.
Time (HH:MM:SS) Enter the current time in hours, minutes, and seconds.