Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 2: Configuration
Extreme Networks EAS 100-24t Switch Software Manual
34
Firmware Information
Information about current firmware images stored on the Switch can be viewed.
To access this window, click Configuration > Firmware Information:
In this window, the following parameters can be configured:
Click on the Boot UP button to set the specific firmware as the boot-up firmware.
Click on the Delete button to remove the selected firmware version.
SNTP Settings Folder
The SNTP Settings folder offers two windows: Time Settings and Time Zone Settings.
Parameter Description
ID States the image ID number of the firmware in the Switch’s memory. The
Switch can store two firmware images for use. Image ID 1 will be the default
boot up firmware for the Switch unless otherwise configured by the user.
Version States the firmware version.
Size (Bytes) States the size of the corresponding firmware, in bytes.
Update Time States the specific time the firmware version was downloaded to the Switch.
From States the IP address of the origin of the firmware.
User States the user who downloaded the firmware. This field may read
“Anonymous” or “Unknown” for users that are unidentified.