Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Telnet Settings
Extreme Networks EAS 100-24t Switch Software Manual
33
Telnet Settings
Telnet configuration is Enabled by default. If you do not want to allow configuration of the system
through Telnet choose Disabled. The TCP ports are numbered between 1 and 65535. The standard TCP
port for the Telnet protocol is 23.
To access this window, click Configuration > Telnet Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
CLI Paging Settings
CLI paging can be Enabled or Disabled in this window. It is Enabled by default. CLI paging settings are
used when issuing a command which causes the console screen to rapidly scroll through several pages.
This command will cause the console to pause at the end of each page.
To access this window, click Configuration > CLI Paging Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Parameter Description
Telnet State Specifies to enable or disable the Telnet settings state.
Port Specifies the port number used for the Web settings. This value must be
between 1 and 65535. The default value is port 23.
Parameter Description
CLI Paging State Specifies to enable or disable the CLI Paging settings state.