Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
DHCP Relay Folder
Extreme Networks EAS 100-24t Switch Software Manual
31
To configure the DHCP Relay Global settings, click Configuration > DHCP Relay > DHCP Relay
Global Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
DHCP Relay Interface Settings
This window allows the user to configure the DHCP Relay Interface Settings.
To configure the DHCP Relay Interface Settings, click Configuration > DHCP Relay > DHCP Relay
Interface Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Click on the Delete button to remove the selected entry.
Parameter Description
DHCP Relay State: This option allows the user to enable or disable the DHCP Relay state.
DHCP Relay / Hops Count Limit
(1-16):
Enter the maximum number of relay agent hops that the DHCP packets can
cross. This value must be between 1 and 16. The default value is 4.
DHCP Relay Time Threshold
(0-65535):
Enter the DHCP Relay time threshold value here. If this time is exceeded; the
Switch will not relay the DHCP packet. This value must be between 0 and
65535. The default value is 0.
Parameter Description
Interface: The name of the IP interface for which to display the current DHCP relay
configuration.
Server IP: Enter the DHCP Server IP address here.