Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 2: Configuration
Extreme Networks EAS 100-24t Switch Software Manual
28
System Log Configuration Folder
This section contains information for configuring various attributes and properties for System Log
Configurations, including System Log Settings and System Log Host.
System Log Settings
This window allows the user to enable or disable the System Log and specify the System Log Save
Mode Settings.
To configure the system log settings, click Configuration > System Log Configuration > System Log
Settings:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
System Log Server
The Switch can send Syslog messages to up to four designated servers using the System Log Server.
To configure the system log settings, click Configuration > System Log Configuration > System Log
Server:
Parameter Description
System Log Use the radio buttons to either enable or disable the system log feature.
Save Mode Use this drop-down menu to choose the method that will trigger a log entry.
You may select from On Demand, Time Interval, and Log Trigger.
min (1-65535) Enter a time interval, in minutes, for which a log entry is to be made.