Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 2: Configuration
Extreme Networks EAS 100-24t Switch Software Manual
20
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
IPv6 Route Settings
The user can configure the Switch’s IPv6 Route Table.
To view the following window, click Configuration > IPv6 Route Settings:
Enter an IPv6 Interface, an IPv6 address in the Default Gateway field and then click the Create button.
In addition, the Metric can be entered between 1 and 65535. The new IPv6 route will be displayed in
the table at the bottom of the window.
IPv6 Neighbor Settings
You can configure the Switch’s IPv6 neighbor settings. The Switch’s current IPv6 neighbor settings will
be displayed in the table at the bottom of this window.
Parameter Description
Interface Name The name of the IPv6 interface being displayed or modified.
VLAN Name Display the VLAN name of the IPv6 interface.
Admin. State Display the current administrator state.
IPv6 Address Enter the IPv6 address of the interface to be modified.
Automatic Link Local Address Toggle between Enabled and Disabled. Enabling this is helpful when no
external source of network addressing information is available.
NS Retransmit Time
(0-4294967295)
Enter a value between 0 and 4294967295. This is the neighbor solicitation’s
retransmit timer in milliseconds. The default is zero.