Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
LLDP Folder
Extreme Networks EAS 100-24t Switch Software Manual
191
After clicking the Show Normal button, the following window will appear:
In this window, the following parameters can be configured:
To find the specific entry entered, click on the Find button.
To view the brief display for the selected port, click on the Show Brief button.
In this window the user can view detailed information for each individual category listed by clicking on
the Show Detail link next to it.
LLDP Remote Port Information
To view this window, click Monitoring > LLDP > LLDP Remote Port Information:
In this window, the following parameters can be configured:
To find the specific entry entered, click on the Find button.
To view the normal display for the selected port, click on the Show Normal button.
Parameters Description
Port Specifies the port to be used for this configuration.
Parameters Description
Port Specifies the port to be used for this configuration.