Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
IPv6 Address Settings
Extreme Networks EAS 100-24t Switch Software Manual
19
Setting the Switch’s IP Address using the Console Interface
Each Switch must be assigned its own IP Address, which is used for communication with an SNMP
network manager or other TCP/IP application (for example BOOTP, TFTP). The Switch’s default IP
address is 0.0.0.0. The default Switch IP address can be changed to meet the specification of your
networking address scheme.
The IP address for the Switch must be set before the Web-based manager can manage the switch. The
Switch IP address can be automatically set using BOOTP or DHCP protocols, in which case the actual
address assigned to the Switch must be known. The IP address may be set using the Command Line
Interface (CLI) over the console serial port as follows:
● Starting at the command line prompt, enter the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/yyy.yyy.yyy.yyy. Where the x letters represent the IP address to be assigned to the IP
interface named System and the y letters represent the corresponding subnet mask.
● Alternatively, the user can enter config ipif System ipaddress xxx.xxx.xxx.xxx/z. Where the x letters
represent the IP address to be assigned to the IP interface named System and the z represents the
corresponding number of subnets in CIDR notation.
The IP interface named System on the Switch can be assigned an IP address and subnet mask, which
can then be used to connect a management station to the Switch’s Telnet or Web-based management
agent.
Successful entry of the command will produce a “Success” message, indicating that the command
execution was correct. You may now utilize this address to configure or manage the Switch through
Telnet, the Command Line Interface (CLI) or the Web-based management (GUI).
IPv6 Address Settings
You can display the Switch’s current IPv6 interface settings.
To view the following window, click Configuration > IPv6 Interface Settings:
To configure IPv6 interface settings, enter an IPv6 Address and click Apply. The new entry will appear
in the table at the bottom of the window.