Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 7: Monitoring
Extreme Networks EAS 100-24t Switch Software Manual
188
Click on the Find button to find a specific entry based on the parameters entered.
Click on the View All button to view all the existing entries.
NOTE
To configure IGMP snooping for the Switch, go to the L2 Features folder and select IGMP Snooping >
IGMP Snooping Settings.
IGMP Snooping Host
This window displays current IGMP Snooping host information on the Switch.
To view this window, click Monitoring > IGMP Snooping > IGMP Snooping Host:
Click the corresponding radio button, enter the VLAN Name, VLAN List, Port List, or the Group to
view IGMP snooping host information, and click Find. The searched entries will be displayed in the
lower half of the window.
MLD Snooping Folder
Browse MLD Router Port
This window displays which of the Switch’s ports are currently configured as router ports in IPv6. A
router port configured by a user (using the console or Web-based management interfaces) is displayed
as a static router port, designated by S. A router port that is dynamically configured by the Switch and
is designated by D, whereas a Forbidden port is designated by F. Enter a VID (VLAN ID) in the field at
the top of the window and click the Find button to display the various types of MLD router ports that
beliong to the specified VLAN.