Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
IGMP Snooping Folder
Extreme Networks EAS 100-24t Switch Software Manual
187
Browse IGMP Router Port
This window displays which of the Switch’s ports are currently configured as router ports. A router
port configured by a user (using the console or Web-based management interfaces) is displayed as a
static router port, designated by S. A router port that is dynamically configured by the Switch is
designated by D, while a Forbidden port is designated by F. Enter a VID (VLAN ID) in the field at the
top of the window and click the Find button to display the various types of IGMP router ports that
belong to the specified VLAN.
To view this window, click Monitoring > IGMP Snooping > Browse IGMP Router Port:
Click on the Find button to find a specific entry based on the parameters entered.
IGMP Snooping Group
This window allows the Switch’s IGMP Snooping Group Table to be searched. IGMP snooping allows
the Switch to read the Multicast Group IP address and source IP address from IGMP packets that pass
through the Switch. The number of IGMP reports that are snooped are displayed in the Reports field.
To view this window, click Monitoring > IGMP Snooping > IGMP Snooping Group:
In this window, the following parameters can be configured:
Parameters Description
VLAN Name The VLAN ID of the multicast group.
VID List (e.g.: 1, 4-6) The VLAN ports of the multicast group.
Group IP Address The IP address of the multicast group.