Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 7: Monitoring
Extreme Networks EAS 100-24t Switch Software Manual
186
The view this window, click Monitoring > Browse ARP Table:
Click on the Find button to find a specific entry based on the parameters entered.
Click on the Show Static button to display all the static entries.
Click on the Clear All button to clear all the entered data from the fields.
Browse VLAN
This window allows the VLAN status for each of the Switch's ports to be viewed by VLAN. Enter a VID
(VLAN ID) in the field at the top of the window and click the Find button.
To view this window, click Monitoring > Browse VLAN:
Click on the Find button to find a specific entry based on the parameters entered.
IGMP Snooping Folder
The following windows are used to configure the IGMP Snooping settings of the Switch.