Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Errors Folder
Extreme Networks EAS 100-24t Switch Software Manual
173
To view the Transmitted (Tx) Table window, click the link View Table, which will show the following
table:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Click on the Clear button to clear the data.
Parameters Description
Port Use the drop-down menu to choose the port that will display statistics.
Time Interval Select the desired setting between 1s and 60s, where "s" stands for seconds.
The default value is one second.
Record Number Select number of times the Switch will be polled between 20 and 200. The
default value is 200.
ExDefer Counts the number of packets for which the first transmission attempt on a
particular interface was delayed because the medium was busy.
CRC Error Counts otherwise valid packets that did not end on a byte (octet) boundary.
LateColl Counts the number of times that a collision is detected later than 512 bit-times
into the transmission of a packet.
ExColl Excessive Collisions. The number of packets for which transmission failed due
to excessive collisions.
SingColl Single Collision Frames. The number of successfully transmitted packets for
which transmission is inhibited by more than one collision.
Collision An estimate of the total number of collisions on this network segment.
Show/Hide Check whether or not to display ExDefer, CRCError, LateColl, ExColl,
SingColl, and Collision errors.
Clear Clicking this button clears all statistics counters on this window.
View Table Clicking this button instructs the Switch to display a table rather than a line
graph.
View Graphic Clicking this button instructs the Switch to display a line graph rather than a
table.