Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Errors Folder
Extreme Networks EAS 100-24t Switch Software Manual
171
To view the Received (Rx) Table window for errors, click the link View Table, which will show the
following table:
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Parameters Description
Port Use the drop-down menu to choose the port that will display statistics.
Time Interval Select the desired setting between 1s and 60s, where "s" stands for seconds.
The default value is one second.
Record Number Select number of times the Switch will be polled between 20 and 200. The
default value is 200.
CRCError Counts otherwise valid packets that did not end on a byte (octet) boundary.
UnderSize The number of packets detected that are less than the minimum permitted
packets size of 64 bytes and have a good CRC. Undersize packets usually
indicate collision fragments, a normal network occurrence.
OverSize Counts valid packets received that were longer than 1518 octets and less than
the MAX_PKT_LEN. Internally, MAX_PKT_LEN is equal to 1536.
Fragment The number of packets less than 64 bytes with either bad framing or an
invalid CRC. These are normally the result of collisions.
Jabber Counts invalid packets received that were longer than 1518 octets and less
than the MAX_PKT_LEN. Internally, MAX_PKT_LEN is equal to 1536.
Drop The number of packets that are dropped by this port since the last Switch
reboot.
Show/Hide Check whether or not to display CRCError, UnderSize, OverSize, Fragment,
Jabber, Drop, and SymbolErr errors.
Clear Clicking this button clears all statistics counters on this window.
View Table Clicking this button instructs the Switch to display a table rather than a line
graph.
View Graphic Clicking this button instructs the Switch to display a line graph rather than a
table.