Specifications
Table Of Contents
- Table of Contents
- Preface Template Formats
- Web-based (GUI) Configuration
- Configuration
- Device Information
- System Information
- Serial Port Settings
- IP Address Settings
- IPv6 Address Settings
- IPv6 Route Settings
- IPv6 Neighbor Settings
- Port Configuration Folder
- Static ARP Settings
- User Accounts
- System Log Configuration Folder
- DHCP Relay Folder
- MAC Address Aging Time
- Web Settings
- Telnet Settings
- CLI Paging Settings
- Firmware Information
- SNTP Settings Folder
- SMTP Settings Folder
- SNMP Settings Folder
- Layer 2 Features
- Jumbo Frame
- VLANs
- 802.1Q Static VLAN
- Q-in-Q Folder
- 802.1v Protocol VLAN Folder
- GVRP Settings
- Asymmetric VLAN Settings
- MAC-based VLAN Settings
- PVID Auto Assign Settings
- Port Trunking
- LACP Port Settings
- Traffic Segmentation
- IGMP Snooping Folder
- MLD Snooping Settings
- Port Mirror
- Loopback Detection Settings Page
- Spanning Tree Folder
- Forwarding & Filtering Folder
- LLDP Folder
- Quality of Service (QoS)
- Security
- Access Control List (ACL)
- Monitoring
- Save and Tools
- System Log Entries
- Trap List
Chapter 7: Monitoring
Extreme Networks EAS 100-24t Switch Software Manual
160
To view this window, click Monitoring > CPU Utilization:
To view the CPU utilization by port, use the real-time graphic of the Switch at the top of the Web page
by simply clicking on a port. The window will automatically refresh with new updated statistics.
In this window, the following parameters can be configured:
Click on the Apply button to accept the changes made.
Parameters Description
Time Interval Select the desired setting between 1s and 60s, where "s" stands for seconds.
The default value is one second.
Record Number Select number of times the Switch will be polled between 20 and 200. The
default value is 200.
Show/Hide Check whether or not to display Five Secs, One Min, and Five Mins.